Installing an ATE device: location, power supply, and points to check

Installing an ATE device requires preparation before drilling into the wall. First, check that the solution matches the diagnosis and that the chosen location covers the area in question. The instructions in the model’s user manual remain the definitive reference.

Choosing the model and installation point together

The coverage radius is measured from the device. Mark this point on the floor plan and identify the furthest areas. The LC15 has a stated diameter of 15 m; the LC30 and the Pulse, 30 m; the MAX, 60 m. The floor plan and diagnosis help confirm the choice.

Read the manual before installation

Download the installation manuals, then check the installation requirements, the distances to be observed, and the intended fixings. Do not apply instructions from another model. If you have any doubts about the wall material or hidden utilities, seek advice before drilling.

Plan for a suitable power supply

ATE devices are mains-powered and are intended to operate according to their manual. Do not open the housing or modify the electrical components. The stated power of 0.75 W represents approximately 6.6 kWh per year when operating continuously; the cost depends on your electricity contract.

Record the wall’s initial condition

Before installation, take dated photos and record the measurement locations. This will make it possible to compare changes without relying solely on the color of the paint or the feel of the surface. Already damaged materials may require separate restoration.

Frequently asked questions

Does “10-minute installation” include the diagnosis?

No. This indication refers to a simple installation under suitable conditions; the diagnosis and preparation must be carried out beforehand.

Can the device be moved without checking the floor plan?

Moving it changes the covered area. Have the new location confirmed by the advice service.